At the end of last winter my picks and crampons were pretty blunt after lots of scratching around in
Most of the routes I end up climbing are mixed routes and so
I need nice sharp points on my picks to get the accuracy needed for those
tenuous hooks. A decent big file and some elbow grease are needed to get them
just perfect, and making sure you keep the teeth all individually sharpened.
For ice pitches a narrowed super sharp pick is the perfect tool for the job,
and the teeth aren’t so useful, in fact they tend to make it harder to get the
pick out when you’ve really whacked it in.
Poor old pick - looking a bit blunt! |
Blunt pick |
Next step is to file the edges of the tip - see picture below. Try and aim to get an angle of about 45 degrees.
Then file the underside of the pick - first the tip as below. Make sure you end up with an angle on the point - ie do not file it to be flat or you won't be able to use the tip of the pick on small holds.
Next file the sides of the teeth - again at around 45 degrees - super useful when using you picks on ice as it gives you a narrow profile pick. See below.
Repeat this process along the top of the pick - as shown below.
The finished profile!! Not perfect but way cheaper than a new set of picks!
Picks can be sharpened a few times but will eventually get too short - and then it's time to get a new set. Hope you find this useful - a few people have been asking me lately what I do with my picks so this is my best attempt at showing you what I do - without hiring a film crew!!
Happy New Year
2 comments:
Andy, do yourself a favour and buy a new file..
Yeah, yeah! Still sharpens......
Post a Comment